User Guide

OmniAccess SafeGuard OS Administration Guide
190
Chapter 5: Setting Up SafeGuard Switches
10.10.2.1 00:12:36:FE:76:06 vlan701 Local n/a
10.10.2.200 00:16:76:4B:65:BB vlan701 Dynamic 0h 2m 52s
10.20.3.1 00:12:36:FE:76:06 vlan702 Local n/a
66.66.66.1 00:12:36:FE:76:06 vlan300 Local n/a
The fields in the output represent:
Showing the ARP Table
To display the contents of the ARP table for the service port (management port), use the
show arp switch command.
show arp switch
Field Description
Age Time (seconds) Displays the time it takes for an ARP entry to age out. This
value was configured into the unit. Age time is measured
in seconds.
Response Time (seconds) Displays the time it takes for an ARP request to timeout.
Response time is measured in seconds.
Retries Displays the maximum number of times an ARP request is
retried.
Cache Size Displays the maximum number of entries in the ARP
table.
Dynamic Renew Mode Displays whether the ARP component automatically
attempts to renew dynamic ARP entries when they age
out.
Total Entry Count Current /
Peak
Displays the total number of entries in the ARP table and
the peak entry count in the ARP table.
Static Entry Count Current
/ Max
Displays the static entry count in the ARP table and
maximum static entry count in the ARP table.
When the brief keyword is not used, the following fields are displayed for each ARP
entry:
IP Address Displays the IP address of a device on a subnet
attached to an existing routing interface.
MAC Address Displays the hardware MAC address of that device.
Interface Displays the routing slot/port associated with the device
ARP entry.
Type Displays the type that was configured into the unit. The
possible values are Local, Gateway, Dynamic and
Static.
Age Displays the current age of the ARP entry since last
refresh (in hh:mm:ss format).