User Guide

OmniAccess SafeGuard OS Administration Guide
174
Chapter 5: Setting Up SafeGuard Switches
Displaying Static Configurations to a Multicast Router
To display information about statically configured multicast routers, use the show
igmpsnooping mrouter command.
show igmpsnooping mrouter [vlan vlanid]
The following sample output is representative of the command without specifying a
VLAN ID.
(SafeGuardOS) #show igmpsnooping mrouter
VlanID Interface
-------- ---------------
2 0/1,0/2
1111 0/1
The next sample is representative of the command when specifying a VLAN ID.
(SafeGuardOS) #show igmpsnooping mrouter vlan 2
VlanID Interface
-------- ---------------
2 0/1,0/2
IGMP Snooping Admin
Mode
Displays whether IGMP Snooping is active on the
VLAN.
Fast Leave Mode Displays whether fast leave mode is enabled or disabled
on the VLAN.
Group Membership
Interval
Displays the amount of time in seconds that a switch
waits for a report from a particular group on a specific
interface that is participating in a VLAN before deleting
the interface from the entry. This value must be greater
than the IGMP V3 Maximum Response time value. The
range is 2 to 3600 seconds.
Maximum Response Time Displays the amount of time the switch waits after it
sends a query on an interface, participating in the VLAN,
because it did not receive a report for a particular group
on that interface. This value must be less than the IGMP
Query Interval time value. the range is 1 to 3599 seconds.
Multicast Router Expiry
Time
Displays the amount of time in seconds that a switch
waits for a query to be received on an interface before
the interface is removed from the interfaces with
multicast routers attached. The range is 0 to 3600
seconds. A value of '0' indicates an infinite time-out,
meaning no expiration.
Field Description