User Guide

OmniAccess SafeGuard OS Administration Guide
172
Chapter 5: Setting Up SafeGuard Switches
To verify that the tables have been cleared, use the Privileged Exec show mac multicast-
table igmpsnooping command. This command is described further in Showing IGMP
Snooping Entries on page 175.
Displaying IGMP Snooping Information
There are Privileged Exec show commands to display IGMP Snooping configurations
and related table information
Showing the IGMP Snooping Configuration
To display or verify the IGMP Snooping configuration, use the show igmpsnooping
command in Privileged Exec mode. The command has the following syntax
show igmpsnooping vlan [vlanid]
The following sample output is representative of the command without specifying a
VLAN ID.
(SafeGuardOS) #show igmpsnooping
Global IGMP Snooping Admin Mode................ Enabled
Multicast Control Frame Count.................. 0
Group Membership Interval...................... 360
Maximum Response Time.......................... 15
Multicast Router Expiry Time................... 2400
(SafeGuardOS) #
Command Use
show igmpsnooping Displays the IGMP Snooping configuration.
show igmpsnooping mrouter Displays information about the statically configured
multicast router interface.
show mac multicast-table
igmpsnooping
Displays the MAC multicast tables managed by IGMP
Snooping.
Syntax Description vlanid (Optional) Displays the IGMP Snooping
information on the VLAN having this
identification number. Valid numbers are from
1 to 4094.