User Guide

OmniAccess SafeGuard OS Administration Guide
163
Chapter 5: Setting Up SafeGuard Switches
Displaying Spanning Tree Settings and Parameters for a Switch
To display STP settings and parameters for a switch, use the show spanning-tree
summary command in the Privileged Exec or User Exec mode.
show spanning-tree summary
The command has no parameters or variables.
The following example displays STP settings and parameters for a switch:
(SafeGuardOS) #show spanning-tree summary
(SafeGuardOS) #
Spanning Tree..................... Enabled
Spanning Tree Version............. IEEE 802.1d
Configuration Name................ 00-12-36-FE-76-FF
Configuration Revision Level...... 2222
Configuration Digest Key.......... 0xac36177f50283cd4b83821d8ab26de62
Configuration Format Selector..... 0
The fields in the output represent:
STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units
received.
RST BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units
sent.
RST BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units
received.
Field Description
Spanning Tree
Adminmode
Enabled or disabled.
Spanning Tree Version Spanning tree version of 802.1 currently supported (IEEE
802.1w, or 802.1d) based on the Force Protocol.
Configuration Name Identifier used to identify the configuration currently
being used.
Configuration Revision
Level
Identifier used to identify the configuration currently
being
used.
Configuration Digest Key Identifier used to identify the configuration currently
being used.
Field Description