User Guide

OmniAccess SafeGuard OS Administration Guide
162
Chapter 5: Setting Up SafeGuard Switches
Displaying Settings for a Port
To display settings and parameters for a specific switch port, use the show spanning-tree
port command in the Privileged Exec or User Exec mode.
show spanning-tree port [slot/port detailed | [slot/port | all] summary |
slot/port statistics]
The following example displays STP information:
(SafeGuardOS) #show spanning-tree port 0/1 summary
(SafeGuardOS) #
MST Instance ID................................ CST
STP STP Port
Interface Mode Type State Role
--------- -------- ------- ----------------- ----------
0/1 Enabled Forwarding Designated
(SafeGuardOS) #show spanning-tree port 0/1 statistics
Hello Time..................................... Not Configured
Port Mode...................................... Enabled
Port Up Time Since Counters Last Cleared....... 0 day 0 hr 7 min 9 sec
STP BPDUs Transmitted.......................... 217
STP BPDUs Received............................. 0
RSTP BPDUs Transmitted......................... 0
RSTP BPDUs Received............................ 0
The fields in the output represent:
Syntax Description slot/port
The desired switch port.
detailed Show detailed settings.
all Show settings for all slot/ports.
summary Show a summary of the settings.
statistics Show statistics.
Field Description
Hello Time Admin hello time for this port.
Port mode Enabled or disabled.
Port Up Time Since
Counters Last Cleared
Time since port was reset, displayed in days, hours,
minutes, and seconds.
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent.