User Guide

OmniAccess SafeGuard OS Administration Guide
160
Chapter 5: Setting Up SafeGuard Switches
Setting the Administrative Switch Port State for all Ports
To set the Administrative Switch Port State for all ports to be enabled, use the spanning-
tree port mode all
command in Global Configuration mode By default the ports are
disabled. To set the Administrative Switch Port State for all ports to be disabled, use the
no version of the command.
spanning-tree port mode all
no spanning-tree port mode all
The commands have no parameters or variables.
(SafeGuardOS)#configure terminal
(SafeGuardOS) (config) #spanning-tree port mode all
(SafeGuardOS) (config) #exit
Displaying STP Information
The following commands allow the display of STP information.
Displaying Spanning Tree Settings for the Bridge
To display STP information for the bridge, use the show spanning-tree command in the
Privileged Exec or User Exec modes.
show spanning-tree
The command has no parameters or variables.
The following example displays spanning tree settings for the bridge:
(SafeGuardOS) #show spanning-tree
(SafeGuardOS) #
Spanning Tree.................................. Enabled
Spanning Tree Version.......................... IEEE 802.1d
Bridge Info:
Priority................................. 32768
Identifier............................... 80:00:00:12:36:FE:76:69
Max Age.................................. 20
Hello Time............................... 2
Forward Delay............................ 15
Hold Time................................ 3
Root Bridge:
Identifier............................... 80:00:00:12:36:FE:76:69
Path Cost................................ 0
Port Identifier.......................... 00:00
Max Age.................................. 20
Forward Delay............................ 15
Hello Time............................... 2
Time Since Topology Change..................... 0 day 0 hr 0 min 3 sec