User Guide

OmniAccess SafeGuard OS Administration Guide
155
Chapter 5: Setting Up SafeGuard Switches
This command forces the BPDU transmission, so the command does not change the
system configuration or have a “no” version.
spanning-tree bdpumigrationcheck [slot/port | all]
The following example forces a transmission of RSTP and MSTP BPDUs on all ports of
the SafeGuard switch:
(SafeGuardOS) #configure terminal
(SafeGuardOS) (config) #spanning-tree bdpumigrationcheck all
(SafeGuardOS) (config) #exit
Setting the Configuration Identifier Name
To set the Configuration Identifier Name for identifying the configuration that a switch is
currently using, use the
spanning-tree configuration name command in Global
Configuration mode. The default value is the base MAC address in hexadecimal notation.
spanning-tree configuration name name
The following example sets “00-12-36-FE-76-FF” as the configuration identifier name that
the switch is using:
(SafeGuardOS) #configure terminal
(SafeGuardOS) (config) #spanning-tree configuration name “00-12-36-FE-76-FF”
(SafeGuardOS) (config) #exit
Setting the Configuration Identifier Revision Level
To set the Configuration Identifier Revision Level for use in identifying the configuration
that a switch is currently using, use the
spanning-tree configuration revision
command in Global Configuration mode. The default level is 0.
To set the Configuration Identifier Revision Level to the default, use the
no version of the
command.
spanning-tree configuration revision revision-level
Syntax Description slot/port Specifies to transmit a BDPU from the
interface that is shown in slot/port format.
all Transmits BDPUs from all interfaces.
Syntax Description name The configuration identifier name. It is string
of up to 32 characters.