User Guide

OmniAccess SafeGuard OS Administration Guide
143
Chapter 5: Setting Up SafeGuard Switches
no vlan association [mac macaddr]
The following command associates a MAC address to a VLAN with the VLAN ID of 50.
(SafeGuardOS) (config) #vlan database
(SafeGuardOS) (Vlan) #vlan association mac 3f:78:45:a2:34 50
(SafeGuardOS) (Vlan) #exit
Verify the configuration using the show vlan association command. This command is
described further in Showing a VLAN Association on page 145.
Configuring IP Subnet-Based VLANs
IP subnet-based VLANs filter Layer 3 information to build VLANs based on a source IP
address, network mask, and the VLAN ID. This type of VLAN permits multiple subnets
on a single interface. IP subnet-based VLANs are typically used when all of the end
points can belong to the same VLAN. These VLANs are defined globally; all traffic from
matching devices are included in the VLAN.
To create an IP Subnet-based VLAN:
1 Creating the VLAN and Assigning a VLAN ID on page 134.
2 Assigning a Name to the VLAN on page 135.
3 Assigning the Egress Port Membership and Optional Tagging for All Ports on page 140.
4 Associate the VLAN to an IP Subnet Address on page 144
5 Assigning an IP Address to the VLAN on page 137.
6 Setting Frame Acceptance on page 138.
7 Enabling Ingress Filtering on page 138.
8 Verify the configuration using the show vlan brief or show running-config
commands. This step is described in Verifying the VLAN Configuration on page 145.
Syntax Description macaddr Species the MAC address being associated to
the VLAN. MAC addresses may be specified in
any of the following formats:
■ aa:bb:cc:dd:ee:ff
■ aabb:ccdd:eeff
■ aa-bb-cc-dd-ee-ff
■ aabb.ccdd.eeff
■ aabbccddeeff
vlanid Specifies the VLAN ID being associated.