User Guide

OmniAccess SafeGuard OS Administration Guide
101
Chapter 2: Accessing and Managing the System
the failed system. Use the show system recovery command in Privileged Exec
mode to check the setting for system recovery.
4 Configure each device to have a peer that synchronizes authentication state. To
add the peer, use the Global Configuration command:
ha peer ip_address
The following example establishes two devices (172.15.4.2 and 172.10.10.1) as
peers:
(SafeGuardOS) # configure terminal
(SafeGuardOS) (config) #ha peer 172.15.4.2
(SafeGuardOS) (config) #ha peer 172.10.10.1
(SafeGuardOS) #
Use the no version of the command to remove a peer:
no ha peer ip_address
The following commands describe the show commands that can be used to show high
availability configuration information.
■ Use the following Global Configuration command to verify the recovery setting
for a peer:
show system recovery
The system either displays that on a critical system error, the system will either
reboot or it will go into pass-through mode.
■ Use the following Global Configuration command to locate a peer device:
show ha peer
The following output is representative of the show ha peer command:
(SafeGuardOS) #show ha peers
HA Peer Table
-------------
Number of Rows:1
Peer ID IP Conns MSG TX MSG RX HB
TX HB RX Connect time