User Guide

8 Quick Start Guide: OmniAcces 600-Series Routers Alcatel
OmniAccess 601 Router Components
The following section identifies and describes the OmniAccess 601 router network ports and LEDs. The 601 routers also
support a Web User Interface which can be used to configure basic operational and security features. For more
information on the Web UI, refer to the OmniAccess 600-series Router Web User Interface User Guide.
Figure 6 OmniAccess 601 Router Front Panel
Figure 7 OmniAccess 601 Router Back Panel
Back Panel Ports
Table 1 provides information about ports located on the router back panel.
Table 1 OmniAccess 601 Back-Panel Ports
port description
WAN 1 WAN connection port. These ports accept cables with RJ-48C connectors. )
Backup WAN An ISDN backup option is supported in releases 8.3 and higher. This option provides a backup if the primary
network connection is lost. This port accepts cables with RJ-45 connectors.
FE 0 - FE 1 Ethernet LAN connection ports. These ports accept cables with RJ-45 cable connectors.
AUX Reverse telnet connection. This port accepts a cable with an RJ-45 cable connector.
Console Console management port. This port accepts a cable with an RJ-45 cable connector.
DC power 12 VDC power connection. This port accepts the 2 mm power connector on the power supply cable that ships
with the OmniAccess 601 router.
Ethernet 0 LEDs Ethernet 1 LEDs
LINK/ACT HS
DUP LINK/ACT HS
DUP
WAN Port
LED
Power LED
Compact Flash
Fast Ethernet
Port 0
Fast Ethernet
Port 1
AUX Port
12 VDC
Input Jack
WAN P o r t
Backup WAN Port
Console
Port