User Guide

Alcatel Quick Start Guide: OmniAcces 600-Series Routers 21
Figure 20 Connecting the OmniAccess 601, OmniAccess 602, and OmniAccess 604 to a Modem
Follow this procedure to connect the OmniAccess 601, OmniAccess 602, and OmniAccess 604 to a modem. Refer to
Figure 20.
1 Connect the male end of the DB-25 adapter to the female DB-25 port on the modem.
2 Connect one end of a supplied RJ-45 cable to the RJ-45 port in the DB-25 adapter.
3 Connect the other end of the RJ-45 cable to the Console port on the OmniAccess 601, OmniAccess 602, and
OmniAccess 604.
4 Configure the modem for 9600 bps, 8 data bits, 1 stop bit, no parity, and XON/XOFF flow control. Refer to your
modem documentation, if necessary. Consult the Alcatel Support website for additional configuration information.
If a workstation is used for the remote management console, use VT-100 terminal emulation software or equivalent,
and configure the software as specified for modems.
Configuring the Router
The following sections introduce commands that you can use to log in as the system administrator, choose a host name,
change the password, set the system date and time, enter an Ethernet IP address, establish a default route, switch modes,
and save the configuration.
Logging In
Login: alcatel
Password: switch
Choosing a Host Name
Alcatel> configure term
Alcatel/configure> hostname ISP_name
ISP_name/configure>
Changing the Password
Alcatel> password
name: alcatel
old password: switch
new password: new_pass