User Guide

Alcatel Quick Start Guide: OmniAcces 600-Series Routers 17
Rack-Mount Installation
Figure 15 Rack Mounting the OmniAccess 602 and OmniAccess 604 Router
Follow this procedure to install the Alcatel OmniAccess 602 and OmniAccess 604 router in an equipment rack using the
optional rack tray assembly. Refer to Figure 15.
1 Determine the mounting position for the rack tray in the equipment rack (front or mid-mount). Attach the mounting
brackets using the six provided 6-32 x .25 inch flat head Phillips screws. Use two screws for the rear bracket holes
and one screw for the front upper hole. (The bottom front hole on each bracket is not used.)
2 Attach the router to the rack carriage using two of the four provided Phillips pan head 4-40 x .25 inch screws.
3 Attach mating Velcro mounting pads to the rack tray and the bottom of the power supply, and then attach the power
supply to the rack tray.
4 Attach the cable retainer bracket to the DC power cord just behind the molded strain relief on the cord.
5 Insert the jack connector on the DC power cord into the 12 VDC port on the back of the router.
6 Engage the captive screw on the cable retainer bracket into the threaded hole adjacent to the DC input jack on the
router. Tighten the captive screw.
7 Slide the mounted router and rack carriage onto the rack tray and engage the thumbscrew on the rack carriage into
the hole provided near the back edge of the rack tray. Tighten the thumbscrew.
8 Connect the network cables to the router ports and roughly dress the cables.