User Guide

16 Quick Start Guide: OmniAcces 600-Series Routers Alcatel
Figure 14 Wall Mounting the OmniAccess 602 and OmniAccess 604 Router
Follow this procedure to mount the Alcatel OmniAccess 601, OmniAccess 602, and OmniAccess 604 router on a
vertical surface. Refer to Figure 14.
1 Attach the router to the wall mount bracket using the four (provided) Phillips pan head 4-40 x .250 inch screws.
Ensure that the router is oriented in a manner that allows the LEDs to be visible.
2 Attach the assembly with the mounted router to the wall surface using the four (provided) 6 x 1 inch (for
OmniAccess 602 and OmniAccess 604) screws or 4 x 1 inch screws (for OmniAccess 601) and hollow wall plastic
anchors.
NOTE: The provided hollow wall anchors are not designed for installation in hard walls. These anchors should only be
installed in a sheet rock (gypsum wall board) wall.
3 Fit the AC strap over the power supply and then place the power supply on the wall mount bracket within the four
locating tabs.
4 Engage and tighten the AC strap captive screw to secure the power supply to the wall mount assembly.
5 Attach the cable retainer to the DC power cord behind the molded strain relief on the cable.
6 Insert the DC power cable jack into the 12 VDC port on the back of the router.
7 Engage and secure the captive screw on the cable retainer in the threaded hole adjacent to the DC input jack on the
router.
8 Connect the appropriate ends of the AC cord to the secured power supply and a 110/120 VAC outlet.