User Guide

12 Quick Start Guide: OmniAcces 600-Series Routers Alcatel
OmniAccess 604 Router Components
The following section identifies and describes the OmniAccess 604router network ports and LEDs. The 604 series
routers also support a Web User Interface which can be used to configure basic operational and security features. For
more information on the Web UI, refer to the OmniAccess 600-series Router Web User Interface User Guide.
Figure 10 OmniAccess 604 Router Front Panel
Figure 11 OmniAccess 604 Router Back Panel
Back Panel Ports
Table 3 provides information about ports located on the router back panel.
Table 5 OmniAccess 604 Back-Panel Ports
port description
WAN 1 - WAN 4 WAN connection port. These ports accept cables with RJ-48C connectors. If drop and insert is configured, then
ports 1 and 2 are reserved for that feature.
FE 0 - FE 1 Ethernet LAN connection ports. These ports accept cables with RJ-45 cable connectors.
AUX Reverse telnet connection. This port accepts a cable with a male DB-9 connector.
Console Console management port. This port accepts a cable with an RJ-45 cable connector.
DC power 12 VDC power connection. This port accepts the 2 mm power connector on the power supply cable that ships
with the OmniAccess 604 router.
WAN Port
LEDs 1-4
Ethernet 0 LEDs Ethernet 1 LEDs
Power LED
LINK/ACT HS
DUP LINK/ACT HS
DUP
WAN Ports 1 - 4 Fast Ethernet
Port 0
Fast Ethernet
Port 1
AUX Port
Console
Port
12 VDC
Input Jack