User Guide

16 Make sure to type wind. Then set the password also to wind. Press the Enter key.
The following text is output to the terminal:
17
Set the flags. Type 0x8a. Press the Enter key.
The following text is output to the terminal:
Set the target name. Press the Enter key.
The following text is output to the terminal:
The name that you use to configure the Alcatel router will become the system prompt.
Ensure that the startup script parameter is blank. The “other” parameter may be blank or left as
“lnPci.”
After entering all the parameters described above, the Alcatel boot prompt, “[Alcatel Boot]” is
displayed.
18
Verify that the settings are correct. Press the Enter key to display the following text:
19 Ty p e @ and press the Enter key to boot from the network.
20 Download the new images. Refer to Upgrading Software on page 43.
ftp password [pw] [blank = use rsh] : wind
flags [f] : Ox8a
target name [tn] :T1000
[Alcatel Boot]: P
boot device
: lnPci
unit number : 0
processor number : 0
host name : host
file name :
tftpdir/8.0/T1000.Z
inet on ethernet [e] : 10.1.0.1:fff0000
host inet [h] : 10.11.12.13
gateway inet [g] : 111.2.3.254
user [u] : wind
ftp password [pw] : ****0
flags [f] : 0x8a
target name [tn] : T1000
ether [e] : lnPci
[Alcatel Boot]: