User Guide

45
Installation Guide: 601, 602, and 604 Routers
9 Press the Enter key.
The following text is output to the terminal:
10
To keep this parameter, press the Enter key.
The following text is output to the terminal:
11
Enter the path-qualified file name: type /software/router/T1000.Z (or whatever is
consistent with the download command in the above example) and press the Enter key.
The following text is output to the terminal:
12
Input the address for the Alcatel system to use as an tftp client to the tftp host. Type
111.2.3.3:ffffff00 (or whatever is appropriate for your network configuration) and press
the Enter key.
Note that the netmask is specified in hexadecimal after a colon (here a 24-bit netmask). You must
be in the same subnet as the tftp host or the same subnet as the default router through which you
will access the tftp host.
The following text is output to the terminal:
13
Press the Enter key. The following text is output to the terminal:
14 At this point, the tftp host address must be entered. Type 192.168.10.1 (or whatever is
consistent with the downloadNCM command in the above example) and press the Enter
key.
The following text is output to the terminal:
15
If a gateway does not exist between the Alcatel router and the tftp server, then this can
be left blank. However, it is required if the router and the tftp server reside in different
subnets. For this example you would enter 111.2.3.254.
The following text is output to the terminal:
[Alcatel Boot]: c
‘_’= clear field; ‘=’ = go to previous field; ^D = quit
boot device : f10 lnPci0
processor number ) 0
host name : host
file name : /flash1/T1000.Z
inet on ethernet [e] : 10.1.0.1:fff0000
inet on backplane [b] :
host inet [h] : 10.11.12.13
gateway inet [g] : 10.11.12.13
user [u] : wind