User Guide

Chapter : RIP Configure Commands 187
Router User Guide
configure router rip interface
This command enables RIP for an interface.
The interface is identified by the interface name. Use ethernet0 for Ethernet 0 and ethernet1 for
Ethernet 1. WAN interfaces are identified by bundle names. If no other RIP interface command is
given, then the interface is configured with default RIP parameters.
parameter definition
syntax:
[ no ] configure router rip interface < name > [ dlci < n > ]
example:
Alcatel-host/configure/router/rip> interface ethernet0
This example configures the Ethernet 0 interface for RIP.
next-level commands
applicable systems:
All models.
name ethernet0, ethernet1, or a bundle name
dlci PVC identifier; enter a number.
Use only for an encapsulated fr bundle.
The range is 16 - 1022.
configure router rip interface authentication
configure router rip interface distribute_list
configure router rip interface metric
configure router rip interface mode
configure router rip interface neighbor
configure router rip interface passive
configure router rip interface split_horizon