User Guide

Running H/F 2 #
Router User Guide
configure router ospf interface dead_interval
This command sets the time, in seconds, that an OSPF neighbor will wait for a hello packet.
Once the user-defined time expires, the interface assumes that the neighbor is down. The value
entered should be approximately four times the value of the hello_interval.
parameter definition
syntax:
[ no ] dead_interval < n >
example:
Alcatel-host/configure/router/ospf/interface> dead_interval 50
related commands
applicable systems:
All models.
dead_interval Time, in seconds
The range is 1- 65535; the default is 40.
configure router ospf interface authentication
configure router ospf interface cost
configure router ospf interface hello_interval
configure router ospf interface neighbor
configure router ospf interface network
configure router ospf interface poll_interval
configure router ospf interface priority
configure router ospf interface retransmit_interval
configure router ospf interface transmit_delay