User Guide

OmniAccess 6000 SC Installation Notes: Installation Guide
6 Part 031657-00 May 2005
FE Port
The FE port provides a 10/100 Mbps Ethernet connection to a network. The
RJ-45 female connector port pin-outs are shown in Figure 2:
FIGURE 2 FE Port
The port accepts a 4- or 8-conductor Category 5 (or better) UTP Ethernet cable
with an RJ-45 male connector. A straight-through cable is required for
connection to a network port. A crossover cable is required for connection to a
management workstation.
For cables that run through plenums or air-handling spaces as described in
NEC (2002) Article 300.22(C), the cable should be suitable under NEC Article
800.50 and marked accordingly for use in plenums and air-handling spaces
with regard to smoke propagation, such as CL2-P, CL3-P, MPP or CMP. Be sure
to install cables in accordance with all applicable local regulations and
practices.
Contacting Alcatel
Web Site
Telephone Numbers
10/100 Mbps Ethernet RJ-45 Female
Pin-Out
1
2
3
4
5
6
7
8
ETH Tx+
ETH Tx–
ETH Rx+
ETH Rx–
Direction
Receive
Transmit
z Main Site http://www.alcatel.com
z Support http://www.alcatel.com/enterprise
z Main US/Canada [phone]
z Main Outside US [phone]