User Guide

OmniAccess 6000: Installation Guide

16 Part 031639-00 May 2005

z The fan tray Fan Status LED is still solid green.

z One the line card:

z The Power LED is still solid green.

z The Status LED is solid green.

z On the supervisor card:

z The power LED is still solid green.

z The Status and Active/Standby LEDs are solid green.

z The Utilization LED panel reflects the expected level of usage.

In a typical power-on test performed after initial installation, a single blinking LED

will indicate utilization of under 1%.

NOTE—For more information on LED behavior, refer to the individual chapters

for the specific modules.

Once the system has passed the initial power-up test:

Connect appropriate network cables (see “The Supervisor Card” and “The

Line Cards” for port and cable information).

You are now ready to perform the initial setup as described in the Alcatel Quick

Start Guide (which is included in the Accessory Kit).