User Guide

Installing the Chassis 9
Chapter 2
Mounting the Chassis
Verify that your rack environment meets requirements (see
“Selecting a Location” on page 8).
Attach the rack mounting brackets to the switch chassis as
shown in Figure 2-2.
FIGURE 2-2 Attaching the Rack Mounting Brackets
The bracket stamped with slot numbers is for the right-hand side of the
switch. Orient both brackets so that the narrow flange faces the front. When
placed properly, the brackets’ large rectangular voids will be positioned over
the side vents to allow proper air flow during operation.
Use a Phillips or cross-head screwdriver to attach each bracket securely with
four 6-32 flat head screws (included).
1
2
S
LO
T
SLO
T
1
S
LOT
SLO
T
3
S
LO
T
1
S
LO
T
3
x 8
6-32
flat head
screws