User Guide

Installing the Chassis 7

Chapter 2

Requirements

Minimum Switch Configuration

An OmniAccess 6000 Wireless LAN Switch must include the following basic

components (as shown in Figure 1-1 on page 2):

z One modular Wireless LAN switch chassis

z One fan tray

z One supervisor card in Slot 0

z One line card in Slot 2

z Adequate power supplies

NOTE—The number and type of power supplies required depends on the number and

type of line cards installed in the chassis (see “Power Management” on page 27).

In most cases, the Alcatel Wireless LAN Switch is shipped with all required

modules installed. If you have received your modules separately, first install

the chassis as described in this chapter, and then see Part 2 of this manual for

instructions on installing each additional module.

Rack Mounting Kit

Using the included rack mounting kit, the Alcatel Wireless LAN Switch can be

mounted in a standard 19-inch network equipment rack. The rack mounting

kit contains the following parts:

FIGURE 2-1 Rack Mounting Kit

NOTE—The six 12-24 screws are intended for securing the switch to the rack.

Some racks require different screws which are not included. Verify that you

have the correct screws or fasteners for your rack system before attempting

to mount the switch.

SLOT

x 6

x 8

Left

Bracket

Right

Bracket

6-32 Flat Head

Screws

12-24 Screws