User Guide

Installing the Chassis 5
CHAPTER 2
Installing the Chassis
This chapter covers the following installation topics:
z Precautions to observe during installation
z Requirements for Alcatel Wireless LAN Switch components
and rack mounting gear
z Selecting a proper environment for the Alcatel Wireless LAN
Switch
z Mounting the Alcatel Wireless LAN Switch in a rack
z Connecting power to the Alcatel Wireless LAN Switch
Pre-Installation Checklist
You will need the following during installation:
 OmniAccess 6000 Wireless LAN Switch components (see
“Minimum Switch Configuration” on page 7).
 OmniAccess 6000 rack mounting kit (see “Rack Mounting Kit”
on page 7).
 Phillips or cross-head screwdriver.
 19-inch equipment rack, or equivalent.
 3U rack space with 10 cm (4 inches) clearance to the left,
right, front, and rear of the rack.
 Another person to help position the switch.
 Alcatel power cord for each power supply, rated to at least 10
A with IEC320 connector.
 Adequate power supplies and electrical power (see “Power
Management” on page 27).
 Cool, non-condensing air 0 to 40 ºC (32 to 104 ºF). May
require air conditioning.
 Console terminal with RJ-45 or DB-9 serial port.
 RS-232 serial cable with RJ-45 male connectors.
 Alcatel serial adapter (included) if connecting to the console
with DB-9.
CAUTION—Installation should be performed by a trained technician.