User's Manual

3 — Replace a G-241W-A indoor ONT
3-4 Alcatel-Lucent 7368 ISAM ONT
Edition 01
I-240W-S I-241W-S I-241W-U Product Guide
3.6 Procedure
Use this procedure to replace a G-241W-A indoor ONT.
1 Deactivate the ONT services at the P-OLT.
If you are using the SLID feature, this step is not required. The ONT and the
services can remain in service (IS).
i Use the RTRV-ONT command to verify the ONT status and th associated
services. Record the serial number or the SLID of the ONT displayed in the
command output.
Example:
RTRV-ONT::ONT-1-1-1-1-1;
ii If the ONT is in service, place the ONT in OOS state.
Example:
ED-ONT::ONT-1-1-1-1-1;
2 If used, disable the Wi-Fi service, as described in Configure a G-241W-A indoor
ONT.
3 Power down the unit by using the on/off power switch; see Figure 3-1 for the
location of the power button.
4 Disconnect the POTS, Ethernet and power and coaxial cables, as well as fiber optic
cables from the ONT; see Figure 3-1 for the connector locations on G-241W-A
indoor ONTs.
Attach the fiber dust cover to the end of the SC/APC connector.
Figure 3-1 G-241W-A ONT connections
See Figure 3-2 for the location of the USB ports on the G-241W-A.
Wi-Fi
Protected
Service button
Reset
button
POTS
ports
(RJ-11)
Ethernet
ports
(RJ-45)
Fiber
optic
connector
Power
connector
Power
on/off
switch
F-type
coaxial
connector
22788