User's Manual

2 — Install a G-241W-A indoor ONT
Alcatel-Lucent 7368 ISAM ONT 2-5
Edition 01
I-240W-S I-241W-S I-241W-U Product Guide
Figure 2-2 Wall mounting keyholes of the G-241W-A indoor ONT without fiber storage
tray attached
iii Attach the fiber storage tray to the wall by drilling the holes in the wall
where the tray will be mounted and then drive the mounting screws into
the holes.
Do not drive the mounting screws into the wall completely. Leave
approximately 1/8 in. (6 mm) between the screw head and the wall
surface.
iv Wrap the optic cable around the spools in the fiber storage tray.
v Attach the fiber storage tray to the wall by placing the screw heads of
the mounting screws into the wall mounting holes, either vertical or
horizontal, on the tray.
vi Slide the ONT enclosure over the fiber storage tray at a forty-five
degree angle and seat the ONT securely on the tray.
Aligning features molded into the fiber storage tray and ONT enclosure
interlock allowing the ONT to seat on the tray.
2 Review the connection locations as shown in Figures 2-3 and 2-4.
22443
Vertical
mounting
keyholes
Horizontal mounting keyholes