User's Manual

Table Of Contents
3 — Replace a G-240WZ-A indoor ONT
3-6 Alcatel-Lucent 7368 ISAM ONT
Edition 01
G-240WZ-A Product Guide
13 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management,
and Troubleshooting Guide for more information.
14 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368
Hardware and Cabling Installation Guide.
15 Activate and test the services; see the 7368 Hardware and Cabling Installation
Guide.
16 If necessary, reset the ONT.
i Locate the Reset button on a G-240WZ-A indoor ONT as shown in Figure 3-1.
ii Insert the end of a straightened paper clip or other narrow object into the
hole in the Reset button to reset the ONT.
17 STOP. This procedure is complete.
Note — A new SLID or the old SLID may be used with the replacement
ONT. If a new SLID is used, the new SLID must also be programmed at
the P-OLT using TL1 or a network manager. If the old SLID is used, no
changes need to be made at the P-OLT; see the operations and
maintenance documentation for the OLT for more details.
R05.04.00 | March 2016 | 3FE-45933-AAAA-TCZZA | Edition 01