User's Manual

2 — Install a G-240WZ-A indoor ONT
Alcatel-Lucent 7368 ISAM ONT 2-5
Edition 01
G-240WZ-A Product Guide
7 If applicable, install the power supply according to manufacturer specifications.
8 Power up the ONT unit by using the power switch.
9 If used, enable the Wi-Fi service.
i Locate the WLAN button on the ONT; see Figure 2-1 for location of the WLAN
button.
ii Press the WLAN button to change the status of the Wi-Fi service.
10 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368
Hardware and Cabling Installation Guide.
11 Activate and test the services; see the 7368 Hardware and Cabling Installation
Guide.
12 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management,
and Troubleshooting Guide.
13 If necessary, reset the ONT.
i Locate the Reset button on a G-240WZ-A indoor ONT as shown in Figure 2-1.
ii Insert the end of a straightened paper clip or other narrow object into the
hole in the Reset button to reset the ONT.
14 STOP. This procedure is complete.
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
R05.04.00 | March 2016 | 3FE-45933-AAAA-TCZZA | Edition 01