User's Manual

2 — Install a G-240WZ-A indoor ONT
2-4 Alcatel-Lucent 7368 ISAM ONT
Edition 01
G-240WZ-A Product Guide
2.6 Procedure
Use this procedure to install a G-240WZ-A indoor ONT.
1 Place the indoor ONT unit:
a On the flat surface, such as a desk or shelf; go to step 3.
b On a wall, go to step 2.
2 Mount the G-240WZ-A indoor ONT on a wall.
The G-240WZ-A indoor ONT must be mounted in a horizontal position, as indicated
by the wall mounting key holes on the bottom of the ONT. If possible, mount the
ONT on a wall stud.
i Attach the wall mount adapter bracket (shipped wit h the ONT) to the two
wall mounting keyholes on the ONT.
Figure 2-1 G-240WZ-A indoor ONT connections and wall mounting key holes
ii Attach the ONT to the wall.
3 Review the connection locations as shown in Figures 2-1.
4 Connect the Ethernet cables to the RJ-45 ports; see Figure 2-1 for the location of
the RJ-45 ports.
5 Route the POTS cables directly to the RJ-11 ports as per local practices.
The POTS port to the left is labeled TEL1 for Line 1 while the port on the right is
labeled TEL2 for Line 2, as shown in Figure 2-1.
6 Connect the power cable to the power connector.
Note — The G-240WZ-A cannot be stacked with another ONT or with
other equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below
the bottom cover
25260
USB2.0 TEL 1-2 LAN 1-4
WPS 2.4G WLAN
WPS 5G
Pairing
Reset
Power
ON/OFF
UPS
USB2.0 TEL1 TEL2 LAN1 LAN2 LAN3 LAN4
WPS 2.4G
WLAN
WPS 5G PAIRING RESET POWER ON/OFF
UPS
R05.04.00 | March 2016 | 3FE-45933-AAAA-TCZZA | Edition 01