User's Manual

1 — G-240WZ-A unit data sheet
Alcatel-Lucent 7368 ISAM ONT 1-7
Edition 01
G-240WZ-A Product Guide
Table 1-3 describes the physical connections for G-240WZ-A indoor ONTs.
Table 1-3 G-240WZ-A indoor ONT physical connections
Note
(1)
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the
power connector.
1.5 G-240WZ-A LEDs
Figure 1-2 shows the G-240WZ-A indoor ONT LEDs.
Connection
(1)
Description
USB ports This connection is provided through 2 USB ports, 1 USB 3.0 and 1 USB
2.0. The ONT supports external USB hard drives that can be made
accessible to all LAN devices.
POTS ports This connection is provided through RJ-11 ports. Up to two POTS
connections are supported.The POTS ports support voice services.
Ethernet ports This connection is provided through Ethernet RJ-45 connectors. Up to
four 10/100/1000 Base-T Ethernet interfaces are supported.The
Ethernet ports can support both data and in-band video services on all
four interfaces.
WPS buttons The Wi-Fi Protected Setup buttons are labeled WPS2.4G and WPS5G.
These buttons enable and disable WLAN data encryption.
Pairing button This button is used to enable or disable the pairing of devices.
WLAN button Wi-Fi service is compliant with IEEE 802.11 standards and is enabled
and disabled using the WLAN button.
Reset button Pressing the Reset button for less than 10 seconds reboots the ONT;
pressing the Reset button for 10 seconds resets the ONT to the factory
defaults, except for the LOID and SLID.
Power input This connection is provided through the power connector. A power
cable fitted with a barrel connector is used to make the connection.
On/Off button This button turns the ONT on or off.
UPS input This connection is provided through a UPS connector.
R05.04.00 | March 2016 | 3FE-45933-AAAA-TCZZA | Edition 01