User's Manual

R05.07.00 | September 2017 | Edition 02

7368 ISAM ONT G-240W-F Product Guide

Replace a G-240W-F indoor ONT

Issue: 01

3FE-47087-AAAA-TCZZA

If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management, and

Troubleshooting Guide for more information.

Note — A new SLID or the old SLID may be used with the replacement

ONT. If a new SLID is used, the new SLID must also be programmed at

the P-OLT using TL1 or a network manager. If the old SLID is used, no

changes need to be made at the P-OLT; see the operations and

maintenance documentation for the OLT for more details.

Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and

Cabling Installation Guide.

Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.

If necessary, reset the ONT.

Locate the Reset button on the side of the G-240W-F indoor ONT as shown in

Figure 25.

Insert the end of a straightened paper clip or other narrow object into the hole in the

Reset button to reset the ONT.

STOP. This procedure is complete.