User's Manual

R05.07.00 | September 2017 | Edition 02
7368 ISAM ONT G-240W-F Product Guide
Install a G-240W-F indoor ONT
Issue: 01
3FE-47087-AAAA-TCZZA
71
11 If used, enable the WPS.
i Locate the WPS button on the side of the ONT; see Figure 23 for location of the WPS
button.
ii Press the WPS button to change the status of the WPS.
12 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368 Hardware and
Cabling Installation Guide.
13 Activate and test the services; see the 7368 Hardware and Cabling Installation Guide.
14 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management, and
Troubleshooting Guide.
15 If necessary, reset the ONT.
i Locate the Reset button on the side of the G-240W-F indoor ONT as shown in
Figure 23.
ii Insert the end of a straightened paper clip or other narrow object into the hole in the
Reset button to reset the ONT.
16 STOP. This procedure is complete.