User's Manual

R05.07.00 | September 2017 | Edition 02
Install a G-240W-F indoor ONT
7368 ISAM ONT G-240W-F Product Guide
70
3FE-47087-AAAA-TCZZA
Issue: 01
4 Connect the Ethernet cables to the RJ-45 ports; see Figure 22 for the location of the RJ-45
ports.
5 Route the POTS cables directly to the RJ-11 ports as per local practices.
The POTS port to the left is labeled 1 for Line 1 while the port on the right is labeled 2 for Line
2, as shown in Figure 22.
6 Connect the fiber optic cable with SC/APC adapter into the SC/APC connector on the bottom
of the ONT; see Figure 23 for the location of the SC/APC connector.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5 in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC
(SC/UPC) fiber optic pigtail cable.
7 Install the power supply according to manufacturer specifications.
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
8 Connect the power cable to the power connector.
9 Power up the ONT unit by using the power on/off switch.
10 If used, enable the Wi-Fi service.
i Locate the WLAN button on the side of the ONT; see Figure 23 for location of the WLAN
button.
ii Press the WLAN button to change the status of the Wi-Fi service.