User's Manual

R05.07.00 | September 2017 | Edition 02
7368 ISAM ONT G-240W-F Product Guide
Install a G-240W-F indoor ONT
Issue: 01
3FE-47087-AAAA-TCZZA
67
6.6 Procedure
Use this procedure to install a G-240W-F indoor ONT.
1 Place the indoor ONT unit:
a On the flat surface, such as a desk or shelf; go to step 3.
Note — The G-240W-F cannot be stacked with another ONT or with
other equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below the
bottom cover
b On a wall; go to step 2.
2 Mount the G-240W-F indoor ONT on a wall.
i The G-240W-F indoor ONT can be mounted in either a horizontal or vertical position.
Figure
21 shows the wall mounting holes for the G-240W-F ONTs.
Figure 21 G-240W-F indoor ONT wall mounting holes (bottom view)
Connections (back)
Antenna Antenna
Fiber cover
US B 1 US B 2 LA N 1 LA N 2 LA N 3 LA N 4 TE L 1 T EL 2 POWER ON/OFF
ON/OFF
buttons (side):
Wall
mounting
hole
RESET
LED
WLAN
WPS
LEDs (front)
Wall
mounting
hole
26033
If possible, mount the ONT on a wall stud
ii Mark the wall with the location of the mounting holes. These holes should be the same
distance apart as the distance between the centers of the keyholes on the ONT.
RE S ET
LE D
WL AN
WP S