User's Manual

R05.07.00 | September 2017 | Edition 02
G-240W-F unit data sheet
7368 ISAM ONT G-240W-F Product Guide
52
3FE-47087-AAAA-TCZZA
Issue: 01
Figure 15 G-240W-F ONT Reset, LED, WLAN, and WPS buttons and fiber
optic connection (bottom and side view)
Connections (back)
Antenna Antenna
Fiber raceway
US B 1 US B 2 LA N 1 LA N 2 LA N 3 LA N 4 TE L 1 T EL 2 POWER ON/OFF
ON/OFF
buttons
(side)
Fiber optic port
LEDs (front)
26032
Table 5 describes the physical connections for G-240W-F indoor ONTs.
Table 5 G-240W-F indoor ONT physical connections
Connection
(1)
Description
USB
(USB port)s
This connection is provided through two USB 2.0 ports on the back of the ONT.
The voltage rate is 5V, and the current rate is 500mA per port.
LAN1-LAN4
(RJ-45 Ethernet ports)
This connection is provided through Ethernet RJ-45 connectors on the back of the
ONT. Up to four 10/100/1000 Base-T Ethernet interfaces are supported.The
Ethernet ports can support both data and in-band video services on all four
interfaces.
TEL1, TEL2
(RJ-11 POTS ports)
This connection is provided through RJ-11 ports on the back of the ONT. Up to two
POTS connections are supported. The POTS ports support voice services.
POWER
(Power input)
This connection is provided through the power connector on the back of the ONT.
A power cable fitted with a barrel connector is used to make the connection.
ON/OFF
This button on the side of the ONT turns the ONT on or off.
RESET
Pressing the Reset button, located on the side of the ONT, for less than 10
seconds reboots the ONT; pressing the Reset button for 10 seconds resets the
ONT to the factory defaults, except for the LOID and SLID.
LED
(LED indicator button)
This button, located on the side of the ONT, turns all LED indicators on or off.
WLAN
(Wireless On/Off button)
Wi-Fi service is compliant with IEEE 802.11 standards and is enabled or disabled
using the WLAN button on the side of the ONT.
(1 of 2)
RE S ET
LE D
WL AN
WP S