User's Guide
Table Of Contents
- 7368 ISAM ONT G-240W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-240W-F unit data sheet
- 5.1 G-240W-F part numbers and identification
- 5.2 G-240W-F general description
- 5.3 G-240W-F software and installation feature support
- 5.4 G-240W-F interfaces and interface capacity
- 5.5 G-240W-F LEDs
- 5.6 G-240W-F detailed specifications
- 5.7 G-240W-F GEM ports and T-CONTs
- 5.8 G-240W-F performance monitoring statistics
- 5.9 G-240W-F functional blocks
- 5.10 G-240W-F standards compliance
- 5.11 G-240W-F special considerations
- 6 Install a G-240W-F indoor ONT
- 7 Replace a G-240W-F indoor ONT
- 8 Configure a G-240W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-240W-F Product Guide Replace a G-240W-F indoor ONT
Issue: 01 Edition 01 79
Figure 26 G-240W-F indoor ONT fiber optic port (bottom view)
i Unplug the fiber optic cable with SC/APC connector from the fiber optic port on the
bottom of the ONT; see Figure 26 for the location of the fiber optic port.
ii Attach a fiber dust cover to the end of the SC/APC (SC/UPC) connector.
6 Replace the ONT with a new unit:
a On a flat surface, such as a desk, substitute the new ONT for the old ONT on a flat
surface, horizontally resting on its four feet.
b On a wall.
i Slide the old ONT off of the mounting screws until the ONT is free of the wall.
ii Slide the wall mount holes on the ONT enclosure over the mounting screws until
it is securely seated.
7 Connect the Ethernet cables directly to the RJ-45 ports; see Figure 25 for the location of the
RJ-45 ports.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
DRAFT