User's Guide
Table Of Contents
- 7368 ISAM ONT G-240W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-240W-F unit data sheet
- 5.1 G-240W-F part numbers and identification
- 5.2 G-240W-F general description
- 5.3 G-240W-F software and installation feature support
- 5.4 G-240W-F interfaces and interface capacity
- 5.5 G-240W-F LEDs
- 5.6 G-240W-F detailed specifications
- 5.7 G-240W-F GEM ports and T-CONTs
- 5.8 G-240W-F performance monitoring statistics
- 5.9 G-240W-F functional blocks
- 5.10 G-240W-F standards compliance
- 5.11 G-240W-F special considerations
- 6 Install a G-240W-F indoor ONT
- 7 Replace a G-240W-F indoor ONT
- 8 Configure a G-240W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-240W-F Product Guide Install a G-240W-F indoor ONT
Issue: 01 Edition 01 69
6.6 Procedure
Use this procedure to install a G-240W-F indoor ONT.
1 Place the indoor ONT unit:
a On the flat surface, such as a desk; go to step 3.
b On a wall, go to step 2.
2 Mount the G-240W-F indoor ONT on a wall.
i The G-240W-F indoor ONT can be mounted in either a horizontal or vertical position.
Figure 20 shows the wall mounting holes for the G-240W-F ONTs.
Figure 20 G-240W-F indoor ONT wall mounting holes (bottom view)
Note — The G-240W-F cannot be stacked with another ONT or with
other equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below the
bottom cover
DRAFT