User's Guide
Table Of Contents
- 7368 ISAM ONT G-240W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-240W-F unit data sheet
- 5.1 G-240W-F part numbers and identification
- 5.2 G-240W-F general description
- 5.3 G-240W-F software and installation feature support
- 5.4 G-240W-F interfaces and interface capacity
- 5.5 G-240W-F LEDs
- 5.6 G-240W-F detailed specifications
- 5.7 G-240W-F GEM ports and T-CONTs
- 5.8 G-240W-F performance monitoring statistics
- 5.9 G-240W-F functional blocks
- 5.10 G-240W-F standards compliance
- 5.11 G-240W-F special considerations
- 6 Install a G-240W-F indoor ONT
- 7 Replace a G-240W-F indoor ONT
- 8 Configure a G-240W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
Configure a G-240W-F indoor ONT
112
7368 ISAM ONT G-240W-F Product Guide
Edition 01 Issue: 01
A classifier rule is used to assign actions to a group of packets based on a set of parameters. A
classification rule must be created against a pre-defined classifier.
Up to 16 policies can be created, with up to 8 classifiers and 32 classifier rules.
1 Select Network > US Classifier from the top-level menu in the GPON Home Gateway
window, and select the Policy tab, as shown in Figure 46.
All classifier policies are displayed in the policy table in the window.
Figure 46 US Classifier Policy window
Table 32 describes the fields in the US Classifier Policy window.
Table 32 US Classifier Policy parameters
2 Select a tunnel interface.
3 Enter a VLAN ID and priority level.
Field Description
Tunnel Type The tunnel type is set to GRE and cannot be modified.
Tunnel Interface Select a tunnel interface from the drop-down menu: No Tunnel, GRE
Tunnel, or LAN traffic.
VLAN ID Enter a VLAN ID (0-4094).
VLAN Tag This field is not configurable. The VLAN tag is set to 8100.
VLAN Priority Enter a VLAN priority level (0 to 7). A lower number indicates a higher
priority.
IP TOS/DSCP This field is not configurable. All tunnel packets are generated with a
default DSCP value (usually 0).
DRAFT