User's Manual

R05.01.01 | December 2014 | 3FE-56678-AAAA-TCZZA | Edition 01
4 — Configure a G-240W-B indoor ONT
Procedure 4-8 LAN networking configuration
1 Select Network > LAN from the top-level menu in the GPON Home Gateway
window, as shown in Figure 4-8.
Figure 4-8 LAN network window
Table 4-7 describes the fields in the LAN network window.
Table 4-7 LAN network parameters
Field
Description
Port Mode:
All Port to L2 Mode
Select this checkbox to set all ports to L2 mode
Port Mode
Port 1 - 4
Drop-down port mode for each port: Route mode or bridge mode
IPv4 Address
IP Address of the ONT
Subnet Mask
Subnet mask of the ONT
DHCP enable
Select this checkbox to enable DHCP
DHCP Start IP
Address
Starting DHCP IP address
DHCP End IP
Address
Ending DHCP IP address
DHCP Lease Time
DHCP lease time (in min)
Bind MAC Address
MAC address to associate to the LAN
Bind IP Address
IP address to associate to the bound MAC address
2 Select the mode for each port.
3 Click Save.
4 Enter the DHCP configuration information.
4-12 Alcatel-Lucent 7368 ISAM ONT
Edition 01
G-240W-B Product Guide