User's Manual

R05.01.01 | December 2014 | 3FE-56678-AAAA-TCZZA | Edition 01
2 — Install a G-240W-B indoor ONT
Note — Fiber cable preparation varies depending on the type and size
of the inside or outside plant fiber cable being spliced to the SC/APC
fiber optic pigtail cable.
Préparation du câble de fibres varie en fonction du type et de
la taille de l'intérieur ou de câble de fibres de plante extérieur étant
assemblés bord à bord pour la SC/APC câble en queue de cochon à
fibres optiques.
7 Install the power supply according to manufacturer specifications.
Note — Observe the following:
• Units must be powered by a Listed or CE approved and marked
limited power source power supply with a minimum output rate of
12 V dc, 1.25 A.
Respectez les onsignes
suivantes:
• Les unités doivent être alimentés par une alimentation de source
d'alimentation limitée répertoriés ou homologués CE et sont
marqués d'un taux de sortie minimum de 12 V cc, 1,25 A
8 Connect the power cable to the power connector.
9 Power up the ONT unit by using the power switch.
10 If used, enable the Wi-Fi service.
i Locate the WLAN button on the ONT; see Figure 2-2 for location of the WLAN
button.
ii Press the WLAN button to change the status of the Wi-Fi service.
11 Verify the ONT LEDs, voltage status, and optical signal levels; see the 7368
Hardware and Cabling Installation Guide.
12 Activate and test the services; see the 7368 Hardware and Cabling Installation
Guide.
13 If used, configure the SLID; see the 7368 ISAM ONT Configuration, Management,
and Troubleshooting Guide.
14 If necessary, reset the ONT.
i Locate the Reset button on a G-240W-B indoor ONT as shown in Figure 2-2.
ii Insert the end of a straightened paper clip or other narrow object into the
hole in the Reset button to reset the ONT.
15 STOP. This procedure is complete.