User's Manual

R05.01.01 | December 2014 | 3FE-56678-AAAA-TCZZA | Edition 01
2 — Install a G-240W-B indoor ONT
Do not drive the screw into the wall completely. Leave approximately 1/8 in.
(6 mm) between the screw head and the wall surface.
iv Slide the wall mount keyholes on the ONT enclosure or fiber storage tray
down over the mounting screws until the ONT is securely seated.
3 Review the connection locations as shown in Figures 2-2.
Figure 2-2 G-240W-B indoor ONT connections (back view)
Wireless
On/Off
button
USB 3.0 USB 2.0 TEL1 TEL2 LAN1 LAN2 LAN3 LAN4 POWER ON/OFF UPS
USB
ports
POTS
ports (2)
(RJ-11)
Ethernet
ports (4)
(RJ-45)
Wi-Fi
security
buttons (2)
Reset
button
Power
input
On/Off
button
Fiber
optic
port
24614
4 Connect the Ethernet cables to the RJ-45 ports; see Figure 2-2 for the location of
the RJ-45 ports.
5 Route the POTS cables directly to the RJ-11 ports as per local practices.
The POTS port to the left is labeled 1 for Line 1 while the port on the right is
labeled 2 for Line 2, as shown in Figure 2-2.
6 Connect the fiber optic cable with SC/APC adapter into the SC/APC connector; see
Figure 2-2 for the location of the SC/APC connector.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Câbles de fibres transmettent la lumière laser invisible.
Pour éviter des lésions oculaires ou la cécité, ne jamais regarder
directement dans les fibres, les connecteurs ou adaptateurs.
Warning — Be careful to maintain a bend radius of no less than 1.5 in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend
radius in the cable can result in damage to the optic fiber.
Veillez à maintenir un rayon de courbure d'au moins 1,5
po. (3,8 cm) lors de la connexion du câble de fibre optique. Trop petit
d'un rayon de courbure dans le câble peut entraîner des dommages à
la fibre optique.