User's Manual

R05.01.01 | December 2014 | 3FE-56678-AAAA-TCZZA | Edition 01
2 — Install a G-240W-B indoor ONT
2.6 Procedure
Use this procedure to install a G-240W-B indoor ONT.
1 Place the indoor ONT unit:
a On the flat surface, such as a desk; go to step 3.
Note — The G-240W-B cannot be stacked with another ONT or with
other equipment. The ONT mounting requirements are:
• allow a minimum 100 mm clearance above the top cover
• allow a minimum 50 mm clearance from the side vents
• do not place any heat source directly above the top cover or below
the bottom cover
Le G-240W-B ne peut être empilé avec un autre ONT ou
avec d'autres équipements. Les exigences de montage ONT sont:
• Laisser un espace minimum de 100 mm au-dessus du capot
supérieur
• Laisser un espace minimum de 50 mm à partir des prises d'air
latérales
• Ne placez pas une source de chaleur directement au-dessus du
capot supérieur ou inférieur à la couverture inférieure
b On a wall, go to step 2.
2 Mount the G-240W-B indoor ONT on a wall.
i The G-240W-B indoor ONT can be mounted in either a horizontal or vertical
position, as shown in Figure 2-1. If possible, mount the ONT on a wall stud.
Figure 2-1 Wall mounting keyholes on G-240W-B indoor ONTs
Keyholes for horizontal mounting
Keyholes for
vertical
mounting
RESET
24111
ii Mark the wall with the location of the mounting holes. These holes should be
the same distance apart as the distance between the centers of the keyholes
on the ONT.
iii Drill the two holes in the wall where the ONT will be mounted and then drive
the mounting screws into the holes.
The recommended length of mounting screw is 1.15 in. (3.8 cm).