User's Manual

1 — G-240W-A unit data sheet
1-8 Alcatel-Lucent 7368 ISAM ONT
Edition 02
G-240W-A Product Guide
Note
(1)
The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the
power connector.
1.5 G-240W-A LEDs
Figure 1-3 shows the G-240W-A indoor ONT LEDs.
LAN1-LAN4
(RJ-45 Ethernet ports)
This connection is provided through Ethernet RJ-45 connectors. Up to
four 10/100/1000 Base-T Ethernet interfaces are supported.The
Ethernet ports can support both data and in-band video services on all
four interfaces.
WPS
(Wi-Fi security button)
The Wi-Fi Protected Setup (WPS) button enables and disables WLAN
data encryption.
WLAN
(Wireless On/Off button)
Wi-Fi service is compliant with IEEE 802.11 standards and is enabled
and disabled using a Wireless button.
Reset Pressing the Reset button for less than 10 seconds reboots the ONT;
pressing the Reset button for 10 seconds resets the ONT to the factory
defaults, except for the LOID and SLID.
USB
(USB port)
This connection is provided through one of two USB ports, one on the
back of the ONT, and one on the side.
Power
(Power input)
This connection is provided through the power connector. A power
cable fitted with a barrel connector is used to make the connection.
ON/OFF This button turns the ONT on or off.
USB
(USB port)
This connection is provided through one of two USB ports, one on the
back of the ONT, and one on the side.
LED
(LED indicator button)
This buttons turns all LEDs on or off.
Connection
(1)
Description
(2 of 2)
R05.02.01 | October 2015 | 3FE-45360-AAAA-TCZZA | Edition 02