User's Manual

5 — ONT configuration file over OMCI
Alcatel-Lucent 7368 ISAM ONT 5-5
Edition 02
G-240W-A Product Guide
Procedure 5-1 Configuring an ONT using a configuration file via OMCI
1 Generate the TAR file to be uploaded to the OLT.
Using the raw configuration file(s) provided by Alcatel-Lucent, generate the TAR
file as follows:
i On a Linux platform, rename the raw configuration file to adhere to the
naming convention, as described in section 5.2.
ii Tar the ABCXXXXVER raw configuration file:
tar -cf ABCXXXXVER.tar ABCXXXXVER
Where
ABCXXXXVER
Is the name of the file created in step i.
This creates two files: ABCXXXXVER and ABCXXXXVER.tar.
iii Rename ABCXXXXVER to ABCXXXXVER.org
iv Remove the “.tar” extension from ABCXXXXVER.tar file.
2 Upload the ABCXXXXVER TAR file to the /ONT/ directory in the OLT.
A maximum of 250 files can be kept in the OLT file system.
3 Using OLT commands, download the TAR file to the ONT.
For OLT commands, refer to the 7360 ISAM FX CLI Command Guide for
100_320Gbps FD NT and FX NT.
Please note:
• pri-cfgfile-pland/dnload or sec-cfgfile-pland/dnload can be 1
to 14 characters.
• pri-cfgfile-pland and pri-cfgfile-dnload should be the same name.
Examples
Note: X can be 1 or 2 unless specified:
i If pland-cfgfileX= Disabled and dnload-cfgfileX= Disabled ,
no file will be downloaded to the ONT.
ii If pland-cfgfileX=FILENAME1 and dnload-cfgfileX= Disabled ,
FILENAME1 will be downloaded and FILENAME1 will be made active. An ONT
reboot is required.
iii If pland-cfgfileX=Disabled and dnload-cfgfileX= FILENAME2
FILENAME2 will be downloaded and FILENAME2 will be made passive. An ONT
reboot is not required.
iv If pland-cfgfileX=FILENAME3 and dnload-cfgfileX= FILENAME 4,
the OLT reports an error because the filenames are not the same.
R05.02.01 | October 2015 | 3FE-45360-AAAA-TCZZA | Edition 02