User's Manual
Table Of Contents
- 7368 ISAM ONT G-120W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-120W-F unit data sheet
- 5.1 G-120W-F part numbers and identification
- 5.2 G-120W-F general description
- 5.3 G-120W-F software and installation feature support
- 5.4 G-120W-F interfaces and interface capacity
- 5.5 G-120W-F LEDs
- 5.6 G-120W-F detailed specifications
- 5.7 G-120W-F GEM ports and T-CONTs
- 5.8 G-120W-F performance monitoring statistics
- 5.9 G-120W-F functional blocks
- 5.10 G-120W-F standards compliance
- 5.11 G-120W-F special considerations
- 6 Install a G-120W-F indoor ONT
- 7 Replace a G-120W-F indoor ONT
- 8 Configure a G-120W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
7368 ISAM ONT G-120W-F Product Guide Replace a G-120W-F indoor ONT
Issue: 01 3FE-46922-AAAA-TCZZA 73
7.6 Procedure
Use this procedure to replace a G-120W-F indoor ONT.
1 Deactivate the ONT services at the P-OLT.
If you are using the SLID feature, this step is not required. The ONT and the services can
remain in service (IS).
i Use the RTRV-ONT command to verify the ONT status and th associated services.
Record the serial number or the SLID of the ONT displayed in the command output.
Example:
RTRV-ONT::ONT-1-1-1-1-1;
ii If the ONT is in service, place the ONT in OOS state.
Example:
ED-ONT::ONT-1-1-1-1-1;
2 If used, disable the Wi-Fi service by pressing the WLAN button; see Figure 23 for the location
of the WLAN button on the back of the ONT.
Figure 23 G-120W-F indoor ONT connections
3 Power down the unit by using the on/off power switch.
4 Disconnect the POTS, Ethernet, and power cables.
TELGPON LAN2 LAN1
POWER
RESET WLAN WPS LED ON/OFF
Fiber
connection
POTS
port
Ethernet
Ports (2)
Power
input
Reset
ONT
Antenna Antenna
Wireless
on/off
WPS
on/off
LEDs
on/off
ONT
on/off
26048
R05.06.01 | June 2017 | Edition 01