User's Manual

Install a G-120W-F indoor ONT
68
7368 ISAM ONT G-120W-F Product Guide
3FE-46922-AAAA-TCZZA Issue: 01
The recommended length of mounting screw is 1.15 in. (3.8 cm).
Do not drive the screw into the wall completely. Leave approximately 1/8 in. (6 mm)
between the screw head and the wall surface.
iv Slide the wall mount keyholes on the ONT enclosure down over the mounting screws
until the ONT is securely seated.
3 Review the connection locations as shown in Figure 22.
Figure 22 G-120W-F indoor ONT connections
4 Connect the Ethernet cables to the RJ-45 port.
5 Route the POTS cables directly to the RJ-11 ports as per local practices.
6 Connect the fiber optic cable with SC/APC adapter into the SC/APC connector.
Danger — Fiber cables transmit invisible laser light. To avoid eye
damage or blindness, never look directly into fibers, connectors, or
adapters.
Warning — Be careful to maintain a bend radius of no less than 1.5 in.
(3.8 cm) when connecting the fiber optic cable. Too small of a bend radius
in the cable can result in damage to the optic fiber.
TELGPON LAN2 LAN1 POWER RESET WLAN WPS LED ON/OFF
Fiber
connection
POTS
port
Ethernet
Ports (2)
Power
input
Reset
ONT
Antenna Antenna
Wireless
on/off
WPS
on/off
LEDs
on/off
ONT
on/off
26048
R05.06.01 | June 2017 | Edition 01