User's Manual
Table Of Contents
- 7368 ISAM ONT G-120W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-120W-F unit data sheet
- 5.1 G-120W-F part numbers and identification
- 5.2 G-120W-F general description
- 5.3 G-120W-F software and installation feature support
- 5.4 G-120W-F interfaces and interface capacity
- 5.5 G-120W-F LEDs
- 5.6 G-120W-F detailed specifications
- 5.7 G-120W-F GEM ports and T-CONTs
- 5.8 G-120W-F performance monitoring statistics
- 5.9 G-120W-F functional blocks
- 5.10 G-120W-F standards compliance
- 5.11 G-120W-F special considerations
- 6 Install a G-120W-F indoor ONT
- 7 Replace a G-120W-F indoor ONT
- 8 Configure a G-120W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
Configure a G-120W-F indoor ONT
146
7368 ISAM ONT G-120W-F Product Guide
3FE-46922-AAAA-TCZZA Issue: 01
Procedure 56 SLID configuration
1 Select Maintenance > SLID Configuration from the top-level menu in the SFU GPON Home
Gateway window, as shown in Figure 74.
Figure 74 SLID configuration window
Table 52 describes the fields in the SLID configuration window.
Table 52 SLID configuration parameters
2 Configure the new SLID.
3 Click Save.
4 STOP. This procedure is complete.
8.4 Operator ID
Use the procedure below to modify the operator ID for the G-120W-F.
Field Description
Current SLID Displays current SLID
Input new SLID Enter new SLID
SLID Mode Choose a SLID mode from the drop-down menu: HEX or ASCII
In ASCII mode, the maximum number of characters is 10, for example: abcdefg123.
In HEX mode, the maximum number of characters is 20, for example:
1234567890ABCDEF1234
R05.06.01 | June 2017 | Edition 01