User's Manual
Table Of Contents
- 7368 ISAM ONT G-120W-F Product Guide
- 1 Preface
- Table of contents
- List of figures
- List of tables
- 2 ETSI ONT safety guidelines
- 3 ETSI environmental and CRoHS guidelines
- 4 ANSI ONT safety guidelines
- 5 G-120W-F unit data sheet
- 5.1 G-120W-F part numbers and identification
- 5.2 G-120W-F general description
- 5.3 G-120W-F software and installation feature support
- 5.4 G-120W-F interfaces and interface capacity
- 5.5 G-120W-F LEDs
- 5.6 G-120W-F detailed specifications
- 5.7 G-120W-F GEM ports and T-CONTs
- 5.8 G-120W-F performance monitoring statistics
- 5.9 G-120W-F functional blocks
- 5.10 G-120W-F standards compliance
- 5.11 G-120W-F special considerations
- 6 Install a G-120W-F indoor ONT
- 7 Replace a G-120W-F indoor ONT
- 8 Configure a G-120W-F indoor ONT
- 9 ONT configuration file over OMCI
- Customer document and product support
Configure a G-120W-F indoor ONT
120
7368 ISAM ONT G-120W-F Product Guide
3FE-46922-AAAA-TCZZA Issue: 01
2 Configure port triggering.
3 Click Add.
4 STOP. This procedure is complete.
Procedure 34 DDNS configuration
1 Select Application > DDNS from the top-level menu in the GPON Home Gateway window, as
shown in Figure 52.
Figure 52 DDNS window
Open Protocol Choose the open port protocol from the drop-down menu:
• TCP
• UDP
• TCP/UDP
Trigger Protocol Choose the triggering port protocol from the drop-down
menu:
• TCP
• UDP
• TCP/UDP
Enable Triggering Select this checkbox to enable port triggering
WAN Connection List Choose a WAN connection from the drop-down menu
Note: only active devices are shown on this menu
Field Description
(2 of 2)
R05.06.01 | June 2017 | Edition 01