Instructions

Introduction to the AP Group Web Management System
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 30
Group ID
Identification of the AP group, default is 100.
MQTT Compatibility
Enable to allow AP with lower version firmware (AWOS4.0.0 and before)
to join. The lower version firmware is low-level security on MQTT. By
default, it is not allowed AWOS4.0.0 and before version AP to join.
Note 4-4: AP of a group usually obtains its IP address dynamically from a DCHP server, and it is difficult to
keep the same assigned IP address for the AP. So managing the AP group by the AP’s dynamic IP address can
be difficult. The Group Management IP (GMIP) is a static IP address configured for the AP group web
management, and you can manage the AP group via accessing the URL: http://GMIP:8080 by wired or wireless.
The GMIP is configured on the PVM of the AP group, and you have to make sure the GMIP on the PVM is routable
from your configuring terminal (browser). A recommended method is to choose an idle IP address from the AP
group domain to configure as a GMIP.
Account Management
There are three accounts can login to the Web GUI with different privileges: Administrator, Viewer, and
GuestOperator. Administrator account allows configuring and viewing the whole system, Viewer account
allows checking configuration and monitoring of WLAN operations, while GuestOperator ONLY has the
privilege to edit the guest portal users. Each account can be logged in at the same time. By default, only
the Administrator account is enabled; Viewer and GuestOperator are disabled.
In the Account Management tab, you can enable/disable the Viewer and GuestOperator account, change
the password for Administrator, Viewer and GuestOperator, illustrated in Figure 4-15.
Figure 4-15 Account Management Tab