Instructions

Connecting AP Group via Web Browser
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 13
Note 3-5: If there is no DHCP server in the network, the AP will default to the 192.168.1.254 address. See How to
Configure the AP if there is no DHCP server.
Stellar AP1230 series and AP1311 Access Points can be powered with dual uplinks, with both switch ports POE enabled
only when connected to a standalone or VC of OmniSwitch 6860/E.
• When using dual links, both switch ports should be of speed 1GE and configured as Linkagg (LACP).
• On the slots used for POE, enable capacitor-detection and then connect the ports to Access Points (lanpower <slot>
capacitor-detection enable). Save and certify switch configuration.
• AP1230 series and AP1311 Access Points will always get powered by either uplink, and if the main source goes down,
the backup POE link will power up the Access Point.
Stellar AP1230 series and AP1311 when not POE powered using OmniSwitch 6860/E, but other LAN switches, you can
still use dual uplinks, but please ensure only one uplink is POE enabled.
Using the Initializing Wizard
Initializing wizard page is loaded by connecting to the pre-defined SSID accessing the URL http://mywifi.al-
enterprise.com:8080. Login with the Administrator account and the default password ‘admin’, illustrated in
Figure 3-1. If you want to manage the AP group with HTTPS protocol, refer to Web management with HTTPS.
Figure 3-1 AP Group Login Page
The following are the Initialization Wizards:
Step1: Welcome Page