Instructions

AP UI
Stellar AP User Guide
ALCATEL-LUCENT ENTERPRISE 102
Figure 9-13 Auto Neighbor AP
Figure 9-14 Static Neighbor AP
• Order – Item number of the neighbor AP.
• MAC Address – MAC address of the neighbor AP.
• IP Address – IP address of the neighbor AP.
• Operate – Remove the neighbor AP, only applicable for static neighbor APs.
RF Environment
The RF Environment is used to view Scanning Mode data for APs. Wireless networks operate in
environments with electrical and radio frequency devices that can interfere with network communications.
APs can examine the radio frequency environment in which the Wi-Fi network is operating, identify
interference, and classify its sources. An analysis of the results can then be used to quickly isolate issues
with packet transmission, channel quality, and traffic congestion caused by contention with other devices
operating in the same band or channel.
Note: To view Scanning Mode data for an AP, the AP must be in "Scanning Mode". When an AP is in
Scanning Mode, no clients can associate with the AP.
There are two types of AP Scanning Mode:
• One Time – The scanning mode will last for 5 minutes duration and then return to normal AP mode
in which wireless clients can associate.
• Always – The scanning mode is always active and wireless client is not allowed to associate if the
AP is powered on.
When the scanning mode is terminated automatically (One Time mode) or manually (Always mode), AP will
return to normal AP mode and clients are allowed to connect.